West Mountain Radio Battery Box Spécifications télécharger pdf (Page 3)

West Mountain Radio Operating Manual

DC-to-GO battery box will fit Group Size 24 batteries with the following

dimensions:

Length 10 7/8 in. (276mm)

Width 6 3/4 in. (171mm)

Height 9 7/8 in. (251mm)

Connecting to the Battery

The RED wire with the larger ring terminal is connected to the battery

POSITIVE lug and securely fastened down with the nut. The BLACK wire

with the smaller ring terminal is connected to the battery NEGATIVE lug

and securely fastened down with the nut. Ensure that RED is POSITIVE

and BLACK is NEGATIVE.

Bring the Battery Lead cable out through the front of the battery box to the

Super PWRgate PG40S. Plug into the farthest right connector marked “BAT”.

Neatly fold the excess wire into the box. Next, Plug the Power Connection

Cable into the middle connector on the PG40S marked “OUT” and plug the

other end into the farthest left connector on the RIGrunner 4008 marked

“DCIN”. Make sure the top is oriented so that the large vent is facing the

front. Snap the top into place.

West Mountain Radio carries post-to-stud lug sets. The positive lug matches

the larger size battery post and has a 3/8 inch stud. The negative lug

matches the smaller size battery post and has a 5/16 inc stud.

Using the Strap

The strap may be installed and used both to secure the battery box to the

floor and to restrain the top cover. It also provides the safety precaution in

the event the battery explodes, the plastic box with strap will likely prevent

flying debris and acid.

Note that the strap is easily installed between the RIGrunner and the battery

box.

RIGrunner 4008

There are some considerations to think about. Please read these instructions

carefully before setting up your RIGrunner.

Choosing a mounting location

Pick a location that is close, or central to, most of your radios and

accessories; especially those that draw large amounts of current. Locate

your power source as close as possible to the RIGrunner. Remember that

Anderson Power Products® and Powerpole® is a registered trademark of Anderson Power Products, Inc.

1 2 3 4 5 6 7 8 ... 19 20

Pas de commentaire

West Mountain Radio Battery Box Spécifications Page 3